How to run and upload Paloalto firewall Day 1 Configuration

After you have already registered the PA device, you have an option to run access the Day 1 Configuration tool which helps build a sturdy baseline configuration by providing templates that introduce best practice configuration as a foundation on which the rest of the configuration can be built. This article will show you how to run it and upload to the device.

Step 1: Run Day 1 Configuration

 * After registering the device, you have an option to Run Day 1 Config.

* Please enter the Serial Number of the device you just registered to create a Day 1 Configuration

Note: Placing a Day 1 Configuration on your firewall will replace any other configurations currently in place

* Click Confirm Serial Number to continue.

* Enter the Setup information such as S/N, Device Type, PAN-OS Version, and Hostname.

•Enter the Management Type and info.

•Enter Logging info.

* Click General Config file.

* Paloalto Customer Support generates the configuration file.

Step 2:  Import the prepared Day 1 Configuration file onto your firewall.

* Go to Device>Setup>Operations.

•Click Import named configuration snapshot

* Click Browse…

* Select the Day 1 configuration file, day1config.xml in our example.

* Click OK to import the day 1 config file.

* The config file is uploading.

* Imported is successful.

•Step 3: Upload imported day 1 config file

• In Device>Operations, click Load named configuration snapshot.

* Click narrow down key and select the imported file, day1config in our example

* Click OK to upload the config file.

* The config file has been uploaded. Click Close and refresh the page.

Now, check the configuration.

Please view this step by step video:

Published by

Bob Lin

Bob Lin, Chicagotech-MVP, MCSE & CNE Data recovery, Windows OS Recovery, Networking, and Computer Troubleshooting on http://www.ChicagoTech.net How to Install and Configure Windows, VMware, Virtualization and Cisco on http://www.HowToNetworking.com