Home | Troubleshooting |  Quick Setup  |  Cisco How to  |  Data Recovery  |  Forums   | Blog | IT Exam Practice | Services  | About Us | Chicagotech MVP  | Search  | Contact Us  |                 

 

 

Local to remote Tunnel Setting

To setup Tunnel from local to remote, click Tunnel Setting and enter the WAN IP address of the NETGEAR router, 172.16.0.1 in our case as “The tunnel dendpoint is specified by this IP Address”. here 172.16.0.1 is the gateway IP address of the remote router.


Post your questions, comments, feedbacks and suggestions

Contact a consultant

Related Topics

How to setup VPN between FVS318 and windows 2000
  
Parameters Recommended for FVS318 VPN (Figure)
  
Configuring the Client-to-Gateway VPN Tunnel on the FVS318v3 (Figure)
   How to configure Windows IPSec

   Difference of Tunnel Setting between local to remote and remote to local
How to check the VPN status on FVS318
How to test Netgear ProSafe VPN connection

Previous Page   Next Page
 

 


 

 

Hit Counter   This web is provided "AS IS" with no warranties.
Copyright © 2002-2018 ChicagoTech.net, All rights reserved. Unauthorized reproduction forbidden.