Home | Troubleshooting |  Quick Setup  |  Cisco How to  |  Data Recovery  |  Forums   | Blog | IT Exam Practice | Services  | About Us | Chicagotech MVP  | Search  | Contact Us  |                 

 

 


How to install Netgear ProSafe VPN Client

1. If you're using Windows NT or Windows 2000 or XP, log on as administrator or its equivalent.

2. Insert the NETGEAR Resource CD and Select Installation. Or  Run the setup.exe file from the CD, for example, d:\software\setup\setup.exe.

3. Work through the installation wizard. Unless otherwise instructed, accept the defaults.

4. When the installation completes, click Finish and restarts the computer.

Note: 1. The SafeNet VPN Adapter, which supports L2TP, is installed only when these network components are already installed on your computer: Because Windows 2000 and XP use the native Windows L2TP adapter, the SafeNet L2TP adapter isn't installed on computers running these operating systems.

2. The NETGEAR ProSafe VPN Client lets you configure and switch among multiple profiles for multiple tunnels. You can “Import” predefined configuration profiles. The FVS318.SPD and FVL328.SPD profile files on the NETGEAR ProSafe VPN Client Resource CD under policies folder.

Post your questions, comments, feedbacks and suggestions

Contact a consultant

Related Topics

How to setup VPN between FVS318 and windows 2000
  
Parameters Recommended for FVS318 VPN (Figure)
  
Configuring the Client-to-Gateway VPN Tunnel on the FVS318v3 (Figure)
   How to configure Windows IPSec
   Difference of Tunnel Setting between local to remote and remote to local

How to check the VPN status on FVS318

Previous Page   Next Page
 

 


 

 

Hit Counter   This web is provided "AS IS" with no warranties.
Copyright © 2002-2018 ChicagoTech.net, All rights reserved. Unauthorized reproduction forbidden.